Decorative Aluminium Panel Trim Anodised Finish 9mm Width For UV Panel

Aluminium Trim UV Panel Decoration Wall Protection Board Tile Corner

Application

A. Select one of the following finish options

1. Anodized Finish:

a. COLOUR - Satin Clear 10 / ALUMINUM ASSOCIATION SPECIFICATION - AA-M12C22A31 /

ANODIZING DESCRIPTION: Architectural Class II - Minimum 10μ (0.4 mil) coating

b. COLOUR – Black 18 / ALUMINUM ASSOCIATION SPECIFICATION - AA-M12C22A44 /

ANODIZING DESCRIPTION: Architectural Class II - Minimum 18μ (0.7 mil) coating

B. Primed Finish:

1. Primer – Oven baked, PPG Duracon 100 Beige Primer.

2. For site paint application with high-quality acrylic latex paint or factory pre-finished with high-quality

acrylic latex paint or powder coat

C. ColorMatch® Pre-Finished Custom Color:

1. Factory applied high-quality acrylic latex paint

2. Air dried and cured

Feature

• Suitable For 10mm Panels Only
• 2400mm Length - Chrome Finish
• Used On All 90 Degree Internal Corners
• Low Maintenance - Quick & Easy To Install
• Perfect For Bathrooms, Showers, Kitchens & Wet Walls
• Trims Are Delivered Free When Purchased With Panels

Use

Anodised finish

External applications

The smoothness and hardness of anodised surfaces makes for ease of cleaning. After product installation it is advisable to undertake the following procedure:

• Remove any grease or deposits with organic solvent, such as white spirit.

• Swab down with a diluted solution of mild detergent followed by rinsing with cold clean water.

• After drying, apply furniture cream or wax, to maintain the highest quality surface finish.As with mill finish aluminium, the frequency of cleaning anodised surfaces in the external environment will vary depending on atmospheric conditions. In severely polluted or marine environments cleaning on a regular basis is advised.Fascia claddings, shop fronts, profiles, etc, should be washed over every three months or so, to help maintain the integrity of surface finish.Anodised surfaces which have been neglected for considerable periods of time will often require a more aggressive cleaning procedure. Unfortunately, abrasive cleaning does cause some removal of the anodic film and the objective is to minimise the amount of abrasive cleaning to achieve the desired standard finish.

Specification